Internal Cable Question

superleeds27

superleeds27

superleeds27

Associate
Joined
28 Nov 2011
Posts
1,893
I recently went ahead and bought the Fractal R4 Case which has the USB 3 front header.

The issue is the connecter is a big 20 pin female. My motherboard has the ability, but has 2x10 areas.

Is there anything available a cable that could split the 20 female to 2x10?

If this makes sense?
 
usb3header.jpg


I think you may be confused, the big one you see in this pic is the USB3 one. :)

The others are USB1.0 and USB2.0 (i assume)
 
Did'nt think they put usb 1 on boards anymore 0.o maybe they are both usb 2 and numbered ?

But the big one is usb 3 it should say inside the manual should be a little diagram of where everything goes.
 
I'm looking at getting a white windowed R4, how have you found the quality?

I've heard some horror stories about Fractal QC so I really am dubious about purchasing one!
 
OP are you sure that your mother board has usb 3 header on it if not you may need to get an adaptor to run the wire out the back of the case and into the USB3 on the I/O panel.

Roady said:
I'm looking at getting a white windowed R4, how have you found the quality?

I've heard some horror stories about Fractal QC so I really am dubious about purchasing one!
Click to expand...

I really like my arc midi R2 build quality seems good to me no lose bits, welds all tidy and the HDD trays have no movement unless you press the release leavers. I can't comment on the define but if its anything like my arc then you should be fine.
 
You must log in or register to reply here.
Back
Top Bottom