** WELCOME MAGICOOL TO OCUK **

Anyone used these yet, especially the PRO series?

Looking to replace my AX series with lower FPI rads and these seem to fit the bill.

Want to run my fans at lower speeds but keep temperatures the same if not better.
 
Jony27 said:
Anyone used these yet, especially the PRO series?

Looking to replace my AX series with lower FPI rads and these seem to fit the bill.

Want to run my fans at lower speeds but keep temperatures the same if not better.
Click to expand...

I doubt the PRO versions have much lower FPI than AX rads.

They are 45mm thick, so their FPI would be similar to AX, PE, XT rads.

Your next step up should be 60mm rads if you want a lower FPI, i.e RX, XTX, UT rads.
 
Its just I read on one of the comments that these have 9 FPI?
Also, from looking at the 360 Roundup by Bundslymania(sorry if I got it wrong), the ST30 performs very well at 600rpm.
 
deFiniLoGy said:
I really doubt it.

Normally 9 FPI exist in 60mm thick core.
Click to expand...

lordfletch said:
alphacool ut60 has 12 fpi i believe.
Click to expand...

All the Alphacool rads have 9 FPI. But their tolerance limits are also not great, I've seen anywhere from 8-11 FPI and various amounts of other rad to rad differences. For example, same rad (UT60 360mm version) coolant volume was measured between 450 and 500 mL by 3 different people across 4 different samples with no two samples having the same number.
 
vsg28 said:
All the Alphacool rads have 9 FPI. But their tolerance limits are also not great, I've seen anywhere from 8-11 FPI and various amounts of other rad to rad differences. For example, same rad (UT60 360mm version) coolant volume was measured between 450 and 500 mL by 3 different people across 4 different samples with no two samples having the same number.
Click to expand...

Hopefully that's not the case for the ST30 as I've just ordered the 240mm. Hoping to get the 360 version too.
 
You must log in or register to reply here.
Back
Top Bottom