Questions for phanteks enthoo luxe owners

deviousx

deviousx

deviousx

Associate
Joined
4 Aug 2014
Posts
26
Hey I'm trying figure out best way to set this up.

Is anyone using the Luxe fan controller hub or using the motherboard connectors with splitters?

How you supposed to take the front fan out?

I'm using the h105 how do you setup the connectors i.e pump and fans if using luxe fan controller?
 
I started to but couldn't figure how to run them at different speeds. Used motherboard headers instead with Speedfan and that worked better (Follow a guide to Speedfan, it's not user friendly). Now I have a Lamptron FC6 fan controller.

The front fan is accessed by removing the front panel. Inside are little circulsf split clipsthat can be pinched together (use needle nose pliers) and pushed through. Start at the bottom and pull the bottom of the panel out as you do. It will come away with some persuasion. It can push back in quite easily.

I can't help with the pump as I've not used a h105. I would guess that it has to be on the CPU_Fan header as that will be variable speed.
 
Bickaxe said:
I started to but couldn't figure how to run them at different speeds. Used motherboard headers instead with Speedfan and that worked better (Follow a guide to Speedfan, it's not user friendly). Now I have a Lamptron FC6 fan controller.

The front fan is accessed by removing the front panel. Inside are little circulsf split clipsthat can be pinched together (use needle nose pliers) and pushed through. Start at the bottom and pull the bottom of the panel out as you do. It will come away with some persuasion. It can push back in quite easily.

I can't help with the pump as I've not used a h105. I would guess that it has to be on the CPU_Fan header as that will be variable speed.
Click to expand...

Thanks I wanted to avoid using motherboard headers only because to lazy to do proper cable management but think i'll buy some extenders/splitters and do that.

Also i know how to access the front fan just taking it out looks like a nightmare where need to disassemble most the case or am i getting it wrong?

I'm sure i have lamptron fan controller somewhere but it used to annoy me when you got it too low make like a squealing sound.
 
The front panel will come off without disassembling the case. Just take off the side panels to get to the clips. The front fan cable is routed down the side so don't let the panel fall away.
 
5pq434.jpg


Pinch together with pliers and push through. There are 3 on each side, start at the bottom.
 
oh yes i see what you mean i can easily remove front panel by taking off bottom dust filter and pulling but i meant if i wanted to replace the front fan looks like you have to dissemble the whole front of case underneath the panel as you can't pull the fan out from the sides
 
Unfortunately not. The only way to remove that fan is to take the panel off. Means you can give it a dust at the same time though
 
You must log in or register to reply here.
Back
Top Bottom