Fittings for acrylic tubing

SavellM · 25 Aug 2015 at 17:30

Good choices.

Is there a dampening or cushion for the PrimoChill 240mm AGB CTR Phase II for Laing D5?

IE to dampen vibrations from the pumps?

PFarrey · 25 Aug 2015 at 20:41

Would suggest you get a bending kit. Ek do a kit which you will need if you want to bend tubes

Olivernoko · 25 Aug 2015 at 21:19

SavellM said:
Good choices.

Is there a dampening or cushion for the PrimoChill 240mm AGB CTR Phase II for Laing D5?

IE to dampen vibrations from the pumps?

Im not sure to be honest i don't think that it will be on the bottom of my case though. Im planning on mounting the res to the side, that may reduce the vibrations as the pump itself wont be touching the case.

Or is that a bad idea and should the pump make contact somewhere?

PFarrey said:
Would suggest you get a bending kit. Ek do a kit which you will need if you want to bend tubes

I have a heat gun, also a rubber bend cord, and ill look to see if i can get the bending blocks from somewhere. £30 is a little pricey.... Also they're out of stock currently.

SavellM · 26 Aug 2015 at 09:32

If you are placing it vertical or horizontal the pump still spins and causes vibrations, ie noise.

You can slow down pumps to lower the noise.

But I'm just wondering if there is something like the Shoggy Sandwich to place between and dampen the vibrations.

Olivernoko · 26 Aug 2015 at 14:25

Not sure ill have a look, thanks for the info