• Notice regarding image hosts and attachments. See here.

1 GPU Higher than the other

Soldato
Joined
17 Jun 2005
Posts
6,515
Location
Near Brighton
Hi

I have just re done my watercooling loop. Before it was just one graphics card, now it is 2.

My original and top block / card - I did not reseat the block as its an old style EK one which is irritating to get all the risers / standoff things to allign. Temperatures before were roughly 50 at idle and maybe 75 on load. My radiator was quite blocked with dust.

Now with my rebuilt loop, its as follows:

1st Card - 65 - 70 idle, went to 90 load (stopped at that point)
2nd Card - 35 - 40 idle, load went up to about 50. Both had equal gpu use.

The block setup is like this:

Photobucket is down right now, cant upload pictures, forgive the horrible description, im tired :P

If i label all the "ports" as ABCD (AB Top Card, CD bottom card)

It Goes in A then out the port directly below into C (2nd card) it then comes out the Upper d port into the rest of my loop

Can anyone see anything wrong with what I have done?

The blocks are the same model, just the old one uses the dodgy stand offs you have to put in place, where as the new block the standoffs actually screw in. Im using compression fittings on the outside of the graphics blocks (they are slim / thin ones, so dont need spacers). Im using a 2 slot SLI / Crossfire fitting inbetween the cards.
 
Last edited:
You're by passing the first block near completely by having the feed to the second card coming from directly underneath the intake line for the first card.

You need something like intake to A top, link to second card from B bottom into D top and then outlet from C.

Edit: swapping intake from A to B should also work.
 
Last edited:
I agree it sounds like you are passing the top one completely. If you want to run in series run in A, B -> C, out at D. However sounds like you were trying to set them up in parellel, in which case i believe it should be in A, A->C and B->D, out at D.
 
Thanks for the replies. Photobucket is still down so I cant upload my fail paint skills but I understand now. Will just move from one top port to the other on the top card.

Thanks
 
On air 1 gpu is always hotter than the other, about 10 degrees difference with mine. But with you being on water surely they should both be near the same?
 
On air 1 gpu is always hotter than the other, about 10 degrees difference with mine. But with you being on water surely they should both be near the same?

read above, he has his inputs / outputs all wrong

beside that - you will get difference in temp anyway - though contrary to popular belief, not because the 1st GPU is warming the water going to the 2nd

I run CPU > GPU > GPU in series and my 1st GPU is actually warmer than the 2nd... it's ASIC is also lower and it doesn't overclock as well as the 2nd one

my 2nd GPU runs around 5C cooler than the 1st one
 
Got it mostly sorted. Did as above and temps are much better. Without much of a cpu overclock, temps are:

Idle

GPU 1: 45
GPU 2: 38

Load

GPU 1: 55
GPU 2: 48

I guess the temperature difference might be due to the thermal paste being about 14 months old on the top GPU, but I'm happy with that.
 
That sounds about right for 6950(70) temps, iirc under full load with a pair of locked 6950's I was hitting around 41-44c on each card with a large radiator.
 
Back
Top Bottom