45nm voltage too high on auto, problem?

Hawky89 · 17 Mar 2008 at 21:05

I've been playing around with the overclocking with the stuff in my sig and just now i had just over clocked the chip to 9 x 350 and with the voltage still on auto the board set it to 1.192 which is stock, but when i pushed up the fsb by another 10, when i booted into windows cpuz suddenly read 1.31v, this is supposedly to high for a 45nm chip, i immediately went into the bios and changed it back to stock volts, would this few minutes of being at 1.3v have damaged my chip?

Jokester · 17 Mar 2008 at 21:06

No it won't have done any damage. I've had 1.8V through mine and it still works fine.

Hawky89 · 17 Mar 2008 at 21:08

cool, thanks i just wanted to make sure

Jokester · 17 Mar 2008 at 21:15

Not that I'm suggesting you put 1.8V through yours though.

crazyDAJT · 17 Mar 2008 at 21:24

Jokester said:
I've had 1.8V through mine

madness I tell you, MADNESS....

out I curiosity, what clock was that at??

Jokester · 17 Mar 2008 at 21:25

That got me upto 5.667GHz, not stable mind

.

crazyDAJT · 17 Mar 2008 at 21:27

Jokester said:
That got me upto 5.667GHz, not stable mind .

what cooling?? phase?? or just extrema water with the radiator outside when there is snow on the ground??

Jokester · 17 Mar 2008 at 21:29

Dry ice. I was using the wrong version of CPU-Z so it didn't count for much