ACF 50 - application

Put some of this on last night and it was easier after putting the can in hot water for 10 mins, came out silky smooth. However, a lot came out very fast so had to get a rag for all the dripping. Maybe a cloth is the best bet.

For those that have used it, exactly how do you apply, how much? on what?
 
I sprayed it all over the parts avoiding the brakes and then wiped down.

On parts where I didnt want it to drip off I used a clothes. Its these parts that are showing signs of corrosion.

I have only used it once!
 
Ok, so all over you mean litterally just spray it all over things like the engine, bolts ect ect and just wipe down after?
 
Rather than wiping down after spraying I just use an old inch width paint brush to smooth it over, then just dab the excess over any little bolts etc.

You could also just spray some into a pot (or the cap) first and then just paint it on, so to speak.
 
diverse180 said:
Rather than wiping down after spraying I just use an old inch width paint brush to smooth it over, then just dab the excess over any little bolts etc.

You could also just spray some into a pot (or the cap) first and then just paint it on, so to speak.
Click to expand...

This seems like a much better idea if I am honest, it's just bolt heads that I want protected and a few other things. Would be much more of a defined application and will save on the mess.

Good thinking batman!
 
You must log in or register to reply here.
Back
Top Bottom