AHCI Bios setting with a Gigabyte ex58-ud5

[garsands]

I am in need of help as I don't fully understand how to set my BIOS to run a SSD

I am trying to set it to AHCI mode but not sure what I have to change
listed in the image below are the parts that I think I need to change but not sure what I need to set to what, I have numbered the ones that I think need changing.

It's a OCZ SSD & M/B is a Gigabyte ex58-ud5

Also what SATA ports do I use the GSATA2 or SATA2 ?

I will be using a 2nd HDD not a SSD what port do I use for that drive I have read that I must not have it pluged in while installing windows 7 on the SSD.

Will I need to install the latest Intel RST driver if so is this done in windows when the SSD is up & running ?

I thought I knew about computers but feel like a right newb again

Thanks sorry for all the Q's

 

[Broken Hope]

Set option 1 to AHCI, and option 2 to enabled. Put the SSD on the lowest port you have available, preferrably port 0. Don't use the GSATA ports at all they use a crappy JMICRON controller which is a lot slower than the Intel controller. Stick your normal HDD on the Intel ports too.

Install the RST driver from http://www.station-drivers.com/tele...t_9.6.5.1001full(www.station-drivers.com).exe