Caporegime
- Joined
- 7 Apr 2008
- Posts
- 27,201
- Location
- Lorville - Hurston
Hi all,
I’m currently assembling a custom 3-bay wardrobe (total width ~2448mm, height 2360mm, depth 600mm) made entirely of 18mm panels, including solid 18mm back panels. Each bay is built in two parts: a ~368mm drawer base unit on the bottom, with a ~1992mm tall wardrobe carcass sitting on top (fastened together).
Two of the bays are already built, joined together, and standing in place, although I may dissamble and rebuild one of them again as the leveling is not quite right. Because of the skirting board and uneven walls, there is roughly a 30mm void/gap between the back of the 18mm wardrobe back panel and the wall. There's also only about a 70mm gap between the top of the wardrobe and the ceiling, so I can't easily get behind or over the top of it without dragging the whole thing forward.
The wall behind it is dot-and-dab plasterboard over brick/block.
What’s the cleanest and safest way to anchor this to the wall from inside the cabinets without bowing the 18mm back panels or dropping fixings down into that 30mm void? Would extra-long Corefix fixings work straight through the back panel, or is there a better trick for bridging that gap?
Thanks in advance!
I’m currently assembling a custom 3-bay wardrobe (total width ~2448mm, height 2360mm, depth 600mm) made entirely of 18mm panels, including solid 18mm back panels. Each bay is built in two parts: a ~368mm drawer base unit on the bottom, with a ~1992mm tall wardrobe carcass sitting on top (fastened together).
Two of the bays are already built, joined together, and standing in place, although I may dissamble and rebuild one of them again as the leveling is not quite right. Because of the skirting board and uneven walls, there is roughly a 30mm void/gap between the back of the 18mm wardrobe back panel and the wall. There's also only about a 70mm gap between the top of the wardrobe and the ceiling, so I can't easily get behind or over the top of it without dragging the whole thing forward.
The wall behind it is dot-and-dab plasterboard over brick/block.
What’s the cleanest and safest way to anchor this to the wall from inside the cabinets without bowing the 18mm back panels or dropping fixings down into that 30mm void? Would extra-long Corefix fixings work straight through the back panel, or is there a better trick for bridging that gap?
Thanks in advance!