Antec Pro Flux Question

RobCharles1981

RobCharles1981

RobCharles1981

Associate
Joined
17 Jan 2016
Posts
52
Hi Everyone,

In the last couple of days, I swapped out my past case the fractal define R5 for the Antec Pro Flux. And I spent a few hours putting it all together. And I had and have facing a couple of snags.
The first is the PSU orrentation I tried to figure out how to place my PSU the Corsair 850x so that it goes "side ways" but I've faced a red herring on the screw mounts for the PSU - has anyone had this problem? In the end I had to insert it the "old way"

Anyway after doing all that I doing the cabling at the back and re-looking at it, I can't figure out how the rear side panel goes on? (See attached photos) And it doesn't seem to clip in on the bottom?

https://i.~ibb.co~/SX4GRXp9/20260118-161457.jpg
https://i.~ibb.co~/5pNmLNZ/20260118-161509.jpg
https://i.~ibb.co~/ks5wPnrk/20260118-161627.jpg
https://i.~ibb.co~/C5Tx5gSm/20260118-161649.jpg

Any help and pointers would be great!

Many thanks
Rob
 
Correction, the bottom of the panel has two tabs that "hook" over the bottom lip of the case. You have to slot them over the lip of the case at the bottom, then click the tabs in at the top.

Check the tabs at the bottom on the panel have not been bent in any way.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom