• Notice regarding image hosts and attachments. See here.

Anyone recognise these symptons?

Soldato
Joined
18 Jan 2006
Posts
3,234
Location
Norwich
So, the desktop has decided to die :mad:
I'm wondering if anyone recognises these symptons-
* First BIOS screen shows up fine, then hangs for a couple of mins until it decides to find the RAM, after which it goes at a normal speed.
* Next spends a couple of minutes hung until it decides to find GRUB (Bootloader screen for Linux/ Windows)
* Windows boot is slow as anything, and hangs when the screen flicks off before showing the welcome screen.
* Memtest seems to be working at normal speed.

Haven't tried Linux yet as I'm currently running memtest (12 mins, no errors), although the machine passed both memtest and Orthos when built.
Was working perfectly last night, all I did was shut it down and put the side back on (Had been sitting on my desk for weeks after adding a HDD)
Disks were SMART clear when shut down last night.

Specs:
Asus P5N-E Sli
Q9550, stock
4gb OCZ platinum, stock
HIS HD3870, stock
4 SATA disks & a IDE DVD drive.

Cheers

-Leezer-
 
Last edited:
Always check each memory stick individually, as sometimes if one stick has an error and the other(s) don't, it may not show up.

Swap test each memory stick and boot up.

If one boots up normally and the other one doesn't then we know which stick is faulty.

If both boot up fine then it isn't the memory and could be the HDD (Run a chkdsk /f to solve any HDD errors or bad sectors).

If both boot badly i.e. hangs when booting into windows etc and/or BSOD's, then the memory is shot and you will need replacements.

Hope this helps :)
 
Since the first hang is before it detects the RAM, it's unlikely to be hard disk. I'd still run the disk manufacturer's diagnostic tool first though as it's easy to do.

If the hard disk passes the diagnostic, and the memory shows no errors in memtest, the most likely culprit is the motherboard. You should try a CMOS reset at this point (take the battery out for a few minutes) then a bios update if that doesn't work.

If none of this helps it's knackered :D
 
Having re read the OP it would also be worth taking the side back off to check you haven't trapped a wire or shorted something. Also try removing the new hard disk in case that's somehow the problem.
 
Problem found-
USB joystick had fallen over and was pushing a button :rolleyes:
Wasted three hours of memtest, heck of a lot of searching, and an absolute, utter pain in the neck.
Someone needs to redesign the USB interface if it can do that.....

-Leezer-
 
Back
Top Bottom