Bios settings EK-Top Revo D5 PWM advice

Exibit · 8 May 2017 at 10:14

Hi

Looking for some advice regarding the correct bios setting for the following EK-Top Revo D5 PWM,
I have a custom loop cooling Motherboard Asus Maximus Hero VIII, CPU 6700K & EVGA FTW 1080 GPU the CPU and GPU are running at stock speeds

The pump is connected to the water pump header on the mother board, and PWM mode enabled, looking under monitor in the Bios the pumps RPM is as follows "2593" though this is the RPM with a CPU temp of approx 22c, when the PC boots it maintains temp range at desktop 25c to 28c, playing Battlefield One CPU is hitting 49c

The loop consists of
EK-Top Revo D5 PWM,
EK-Supremacy EVO CPU block
EK Reservoir X3 250
EK Coolstream XE 240 Radiator
EK Coolstream XE 360 Radiator

Glanza · 8 May 2017 at 14:31

Those temps and pump speed look fine.

Exibit · 8 May 2017 at 14:35

Glanza said:
Those temps and pump speed look fine.

Thanks

tyler_jrb · 8 May 2017 at 16:41

Looks good to me. Pump speed doesn't matter a huge amount from testing. Just set it to an rpm your happy with noise wise.

I always ran my dual d5's at around 1780rpm as I found that's when they were quietest and in honesty there was less that 1-2c overall between that and maximum speed.