• Notice regarding image hosts and attachments. See here.

confusong switch off

Associate
Joined
10 May 2009
Posts
90
Hello.
sometimes when i switch my pc on my pc wont fully boot i have vista 64 and it gets to the microsoft bar which indicates windows is loading (before the log on page) but freezes i have to switch off via the psu then swicth back on again to get it working and it will always work the second time the pc shop where i brought the psu blame the motherboard saying thats where the fault obviously lies but im not so sure. my case also has a logo on the front which is supposed to light up but doesnt dispite being plugged in to the psu. several other independant pc stores have also blamed the mobo but that cant be right can it?
 
Welcome to OcuK matey.. more information would Help in solving your dylema
1, Full system speck of your Pc including your PSU wattage .. Always a good start;)
2, Is it a new build
3, Was it ok for a while" before changing the psu
4,Add anything else you think may help:):)
 
hiya,
system spec is amd 5000+ BE cpu, corsair 3gb mms2 ram, asus m3a motherboard, coolermaster hsf, 500gb samsung spinpoint hdd, 650w gold edition psu. the system is less than 8 months old from when i built it. one reason i suspect the psu is at the front of the case is a neon blue dragone thats supposed to light up and it did at first but after 2 months it started to get intermitant and now its never on, this is only connected to the psu i supposed the part that lights up could have gone (its not a bulb its just a kind of black card you can see the dragon etch in it). i hope this help any further advice would be great. i have just started my adventures in overclocking but this problem started before i tinckerd i suppose i shouldnt have started until i know what the problem is?
 
Any unusual beeps at start up does all your hardware show up @ post
Lets just eliminate a few possible problems If it were me I would start by going into bios and reverting all your settings to Default let the board run all your hardware for now,

Use just one stick of your Ram and remove the other two Check your voltage is the correct setting for your Ram and speed default settings should cover this .. if it boots ok test the other two one at a time and let us know how you get on
 
Back
Top Bottom