Cooler Master NR200P ITX Case Build & Mod Project

[Darren_uk]

Oh wait i just realized you have used just a glossy white adhesive paper, not a transparent paper, my bad! Thanks for all your help Darren! and sorry to interrupt you!

your welcome

 

[Darren_uk]

Update: 22/11/20
Swapped out my 2070 Super for an AMD 6800 Reference card,
The first Reference graphics card I have seen with 0DB fan stop.

Note: If you are Using the Riser cable that comes with the NR200P
& a B550/X570 motherboard make sure you set the bios to PCI-E speed to 3.0
before swapping out your old card for a 3000 series or 6800 AMD
otherwise, The PC just beep with a blank screen.
This riser cable only supports up to PCI-E 3.0, not 4.0 or AUTO

 

[Darren_uk]

Great Running in the NR200, Desktop temps stay in the low 30c,
will rise a little more from 60hz to 144hz enabled
fans spin underload gaming reach around 62/72C, MAX Temp of the cards are 105c.

Just as silent than my Gigabyte 2070 super x3 fans card

Very impressed with the 6800.
the 6800 XT will get more hot due to more Watts & performance

 

[Darren_uk]

AMD 6800 Reference card Desktop idle & in-game Temperature

Temps are higher on Desktop with 144hz mode enable due to more GPU power/watts


fans are dead silent in-game.
Setting the Monitor to 60Hz makes the "VRAM CLOCK Speed" goto only 192Mhz
& Power Consumption only 8/16w, making the temps around 34c idle

 

[Darren_uk]

Hi there, does this mod allow you to still use the front IO just from below? Trying to decide what to do with this case in my situation.

Yep all the front I/O are active but harder to reach to attach USB devices.
The only good thing is saves the PC being turned off by the Cat being below

 

[Darren_uk]

Hi there,

I’m just starting my NR200P build! I have a question about your glass side panel. I’d like it to be white as well around the edges, like what you did. I don’t need to drill holes in the glass, but would like it to be surrounded by white Can you explain what you did in that side glass window mod?

Thanks!!

Hello, Sorry for a late reply, not been on the forums that much, If you using the Tampered glass panel that comes with the NR200P version...
(1) don't drill holes in a tampered glass panel, it shatters/ Bang
(2) I did not use the Temp glass panel & ordered an acrylic sheet & cut down to size to drill holes in
(3) are many 'white' Crafting tapes single-sided Adhesive & A4 single-sided Adhesive Sheets from Online stores you can cut to size to place over the black borders,

 

[Darren_uk]

nice very tidy and that graphics card with the fancy lighting is awesome ! how much more than a normal one does that cost ?

did the cat come with the parts ? ha ha

The Coolermaster NR200P was £89, the LED strips & white Arctic P120 fans purchased elsewhere