Coolermaster Stacker cable question?
- Thread starter badbob
- Start date
Easiest way to do this, measure the length of the cables on the PSU and then you compare to the height of the case.
If you can give me the length of the cables on the Liberty I can find out if it *should* fit.
But not having both I can't say 100% just 95% with that information.
You have to remember the PSU is designed to go top to bottom, so bottom to top should not be that much of a problem.
If you can give me the length of the cables on the Liberty I can find out if it *should* fit.
But not having both I can't say 100% just 95% with that information.
You have to remember the PSU is designed to go top to bottom, so bottom to top should not be that much of a problem.
Getting close to ordering it No competitor talk please I can't find the black version 810 CM in the UK.
Anyone fitted a 12cm fan to the side panel? Shouldn't be too difficult, just drill new holes, cut off the area for the smaller fan mount points.
Anyone fitted a 12cm fan to the side panel? Shouldn't be too difficult, just drill new holes, cut off the area for the smaller fan mount points.
Ok going by dimensions and some deductions/approximations.
The 810 case is 53 cm high.
And 58 cm deep
Depending how CM measure it (H x W x D or D x W x H) going by picture I think it's deeper than it is higher.
The 5.25" drives will be around 20 cm deep into the case.
PSU is 15 cm deep.
Take roughly 5cm total off top and bottom due to casing, gaps and the feet.
Convert PSU cables to cm- power is 58cm and drive cables are 76cm.
PSU connectors are 2.5cm from the top of the PSU.
Roughly 45cm vertical distance from the PSU connectors to the top 5.25" drive bay power connector. The horizontal distance from PSU connectors to the bottom 5.25" is 24cm.
So I think I have plenty of slack cable, since the "cable area" is 45cm x 24cm. I could print out the case to scale
and see.
Right I've scaled the side photo 1:1 in PS (56cm deep by 53cm high canvas of case only) then imported that into a larger canvas, then created two lines for the cables, PSU and 5.25" drive boxes also to scale. It looks like I have loads of slack.
The 810 case is 53 cm high.
And 58 cm deep
Depending how CM measure it (H x W x D or D x W x H) going by picture I think it's deeper than it is higher.
The 5.25" drives will be around 20 cm deep into the case.
PSU is 15 cm deep.
Take roughly 5cm total off top and bottom due to casing, gaps and the feet.
Convert PSU cables to cm- power is 58cm and drive cables are 76cm.
PSU connectors are 2.5cm from the top of the PSU.
Roughly 45cm vertical distance from the PSU connectors to the top 5.25" drive bay power connector. The horizontal distance from PSU connectors to the bottom 5.25" is 24cm.
So I think I have plenty of slack cable, since the "cable area" is 45cm x 24cm. I could print out the case to scale
and see.Right I've scaled the side photo 1:1 in PS (56cm deep by 53cm high canvas of case only) then imported that into a larger canvas, then created two lines for the cables, PSU and 5.25" drive boxes also to scale. It looks like I have loads of slack.
Last edited: