Sorry about title, hard to find words tonight???
Ok point of question is!
I raised my Q6600 to 3.6 today booted fine , and so I started intel burn test!
1st time I got a freeze. V-core @ 1.4 (cpu-z reported) not on full load
upped my voltage 1.45
2nd time my screen just went black. as if monitor turned off, excreted a little bodily fluids and returned to bios, where I plonked it back to 3.2
So does this indicate a hole anywhere? i.e voltage or mem or nothing at all?
should I sync my mem or forget that, and just use stock timings, volts and mhz ?
I've read the Oc sticky but as a noob need a few more helpfull pushes in right direction.
merry xmass
Ok point of question is!
I raised my Q6600 to 3.6 today booted fine , and so I started intel burn test!
1st time I got a freeze. V-core @ 1.4 (cpu-z reported) not on full load
upped my voltage 1.45
2nd time my screen just went black. as if monitor turned off, excreted a little bodily fluids and returned to bios, where I plonked it back to 3.2
So does this indicate a hole anywhere? i.e voltage or mem or nothing at all?
should I sync my mem or forget that, and just use stock timings, volts and mhz ?
I've read the Oc sticky but as a noob need a few more helpfull pushes in right direction.
merry xmass