Dell u2311h calibration

It seems like a lot of those settings are a bit much, i just got a rev02, brightness definitely needs to drop to around 30 but messing with the RGB settings gave odd results, having them all at 100 looks fine but i noticed dropping the green to 99 made whites nicer.

Does sharpness 50 mean no post processing then?

One odd thing i noticed was that putting contrast above 75 made whites coloured, going lower doesn't have the same effect, any idea why?
 
Watch out for banding with certain settings, i noticed it was quite bad on certain shades when RGB was set to 100, it also happens in a few presets, here's a colour gradient image to check.

After playing around these settings are the most pleasing to my eye...

Brightness 40
Contrast 75
R 99
G 98
B 99

I think 30 is too low, while you want blacks as black as possible it may be at the expense of a nice bright image, the parts you want to pop out look a bit flat if it's set too low, obviously everyone is different so its best to adjust things how you like.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom