Does not find bootble device SSD?

psychas · 25 May 2011 at 12:46

after buying new ssd swapping it over and installing windows when i should down the pc next time i start it doesnt find the ssd .

So i have to go bios every time and change from ahci mode to ide then again to ahci.

how to sort this problem ?

Ty

psychas · 25 May 2011 at 13:01

no im saying it doesnt detect SSd first time you boot in AHCI mode , so i have to go in to bios change it back to IDE that makes it detectable . then when it is detected on ide mode i change it to ahci as running in ide would be slower.

and its fine till you not should down your pc

psychas · 25 May 2011 at 13:15

yea its connected to first one sata 1

psychas · 25 May 2011 at 13:31

yea it is agility 3 60 gig.

how do i update firmware never had to do it previously ,

im ruining before latest bios on mob can try updating it to latest.

it only happens on cold boot when pc is off for while.

psychas · 25 May 2011 at 13:54

oh i see so mostly everyone has this issue (cold boot on ocz agility) ;/ well my firmware is 2.06 trying to update it to 2.36 says "firmware update not supported on primary drive"

so is it due with firmware they going to fix it later on or SSD faulty it self ?

edit: also i seen that some kind of hot-swap could help if it is enabled in bios were abouts is it

psychas · 25 May 2011 at 14:13

i think 2.36 is for vertex 3 thats why it doesn't update the agility 3 as it doesn't have any newer firmware then 2.06 atm i think?

should they not work properly out of the box tbh ?