Drain point in my tj07

[zx|muppet]

So I have my loop basically done.

I have tried to use a t piece at the bottom of the 2 rads but I don't have enough room to run the t piece and connect the 2 rads together...

I'm using a bitspower 150ml res so I could just fit a fitting to that and turn the pc upside down to drain?

I'm a bit stumped atm with what to do

 

[Undesirable]

If you're using flexible tubing you can attach quick disconnects to make draining easier. Other than that, you'll have to improvise with turning the case as you've described. Some people cut holes in the bottom of the case to make room for drain ports.

 

[LuckyBenski]

I hid mine under a PSU shroud, right below the pump/Res and next to my bundled spare PSU cables. It's tight and scary, but works. Lowest point in the loop and all that. You need the top of the reservoir available to let air IN, unless you plan to break the loop elsewhere.

You need two open points, honestly.

 

[zx|muppet]

I've ordered some more 90 degree fittings and also a male to male connection to see if that allows me to fit it all in the bottom