Draining my system...

[pgi947]

Hi again

So tomorrow I will be plodding on with Project ES, I have methods to drain my system, I was just curious about the water that will be left in my blocks.

Is there a method to drain the absolute most out of my system?

Just a little worried that for example when I disconnect the tubing going from my CPU block to the first GPU block, a little water will be left in a block that could potentially drip on to some vitals.

Just De-Ionised with additives in at the moment.

 

[pgi947]

I wouldn't worry about a little dripping, if your paranoid, you could use a carrier bag? or some paper towels, or just waggle your case around to get the fluid out as much as you can

The simple things I constantly manage to over look in a paranoid haze

Will running the pump (D5 vario) with no fluid in the system damage it? Just to give mavity a helping hand.

 

[pgi947]

Thanks guys, lowest point will be the outlet running from GPU to rad, has around 8" of hose on it too so I can be damn sure its the lowest thing in the loop

Would adding pressure to the inlet be a good idea? i.e. blowing down the intake side to push more out?

 

[pgi947]

Thanks guys, been a pleasure as always

Will let mavity do its thing and have plenty of kitchen roll on stand by.