Draytek enable web config???

Cyber-Mav · 10 Jun 2015 at 19:50

hello I got a draytek 2820n the web config has been turned off but I can use telnet to get into it fine. anyone know the command to enable the web config again?

Prophet · 10 Jun 2015 at 20:06

I've had this before when the web interface hasn't been turned off. Sometimes you have to access it via a port which I can't remember right now. However a factory reset should resolve this if you're OK losing your settings.

Cyber-Mav · 10 Jun 2015 at 20:32

cant factory reset it, its got too big a config on it to loose. I tried the web ports 80 and 8080 but no luck, only telnet works fine but is limiting on what I can do.
any other suggestions?
may have to phone draytek support tomorrow

Prophet · 10 Jun 2015 at 20:45

Export a backup using telnet, factory reset, restore backup using GUI :cool:

tribz · 10 Jun 2015 at 21:20

Try this, page 65 looks like it might help or section 2.16

http://draytek.com.vn/download/TelnetCommands.pdf

bluebeatle · 11 Jun 2015 at 13:37

Have you tried HTTPS?

shatpank81 · 13 Jun 2015 at 20:46

if the port/box as been ticked to allow remote access etc try port 443
and put https:// before the ip address of the router

Caged · 13 Jun 2015 at 22:53

You can't turn the web UI off as far as I know, only change the ports or turn the web UI off for remote access.

Try scanning it for open ports from the LAN side.

stuie · 16 Jun 2015 at 14:03

might get you started

mngt rmtcfg ?