Enthoo Luxe

Rustyone · 9 Nov 2015 at 22:01

Can any Enthoo Luxe owners tell me the space behind the motherboard tray and the door ?

And any views on the case in general, bad / good.

Bickaxe · 10 Nov 2015 at 01:47

Great case.
Approx 25mm, enough for cable management and a few SSD's
There is no door on the case

bioshockeruk · 10 Nov 2015 at 11:40

I can give you an exact measurements this afternoon but it is quite spacious. I have a ton of cable extensions all braided alongside various temp probes and fan cables running behind.

Rustyone · 10 Nov 2015 at 12:29

It's mainly to see if there is space for tubing, it seems to have a deeper sction at the bottom with space for a double ssd bracket, but is less space above that.

25mm might just do the trick.

bioshockeruk · 10 Nov 2015 at 12:40

It does have a deeper recess along the bottom. And I have tucked my drainage tube there so you should be good.

Rustyone · 10 Nov 2015 at 15:09

bioshockeruk said:
It does have a deeper recess along the bottom. And I have tucked my drainage tube there so you should be good.

The plan is 2 tubes behind the motherboard tray, need to run from top to bottom roughly where the grommets are, so that would be the narrower space, which seems to be 25mm according to the other post.

D1craig · 10 Nov 2015 at 16:05

You can fit atleast two Samsung evo ssds on top of each other if that helps

Rustyone · 10 Nov 2015 at 18:05

D1craig said:
You can fit atleast two Samsung evo ssds on top of each other if that helps

It's not the space for SSD's it to run watercooling tube behind the motherboard area, so it's the depth between the motherboard tray and side panel.
The narrow part at the top area not the deeper part at the base.

bioshockeruk · 10 Nov 2015 at 19:56

What size tubing? It should fit fine. It is 26.5mm at the top and 37.5mm at the bottom. Hope this helps.

Rustyone · 11 Nov 2015 at 18:01

bioshockeruk said:
What size tubing? It should fit fine. It is 26.5mm at the top and 37.5mm at the bottom. Hope this helps.

13mm tube, but it depends on the bend, if a 90d fitting is used it takes up more space, case of trying I suppose, or sticking a bit of solid tube at the back.