Error Warning!

PilotTait

PilotTait

PilotTait

Associate
Joined
9 Nov 2006
Posts
158
Location
Scotland
Sometimes when I start my pc for the first time of the day I get the following on the boot screen:

"Warning! Now system is in safe mode.
Please reset CPU or Memory Frequency in CMOS setup"

Why am I being given this message? I haven't overclocked, however, I have changed the speeds to that they should be (the RAM installed at a lower speed, as did the CPU multiplier)

Any ideas? I can get round it by pressing F1 to continue but its quite annoying.
 
Ill increase the RAM voltage a bit, see how it works, Its still below the spec, i think i have my RAM voltage at 2.00 and its range is 1.9-2.3 or something.

As for the power settings, not sure about that, not sure how to check. I have a QX6700 and Iv set the multiplier to 10X so it runs at the spec speed of 2.67GHz
 
ntune.jpg


You said take a look at the 3.3v, 5v and 12v rails in the BIOS...
Thats the tool that comes with the motherboard... That give enough info?
 
You must log in or register to reply here.
Back
Top Bottom