F4 BSOD Error

Sneakze · 16 Dec 2013 at 19:02

I made a thread last month in regards to the amount of bluescreens i was getting. So i've updated my bios & enabled the XMP profile on my RAM, and since then no issues. As of today, the taskbar just dissapeared out of no where and then BSOD with the F4 error again. Looked on Bluescreenviewer and its a driver called ntoskrnl.exe causing the problem.

Any suggestions?

setter · 16 Dec 2013 at 19:06

F4 for me a while back was a sign of a faulty ssd, (ocz vertex 2e 120gb) try running chkdisk to see how it go's.

Sneakze · 16 Dec 2013 at 19:10

I'll probably give this a go tomorrow, as it can take a few hours depending on the amount of files on the drive?

wazza300 · 16 Dec 2013 at 19:10

yeah f4 is hdd/ssd related error

any fw updates for your sandisk? if its sandforce controlled their might be issues with it running on z87 chipset and intel sata ports

try asmedia or marvell sata ports if you have them

Sneakze · 16 Dec 2013 at 19:24

Latest firmware for my ssd. Not a clue about these other sata ports, how would i find out?

wazza300 · 16 Dec 2013 at 19:30

motherboard manual should tell you,they might all be intel but not sure

some are mixed on certain boards

EDIT ive checked they are all intel sata ports so idk whatelse you can try?

Sneakze · 16 Dec 2013 at 19:39

Hmm not too sure myself either tbh. This only happens when the PC is underload >.<

SiDeards73 · 16 Dec 2013 at 19:39

I have an Asrock mobo and there was something in the manual about not using Marvell ports for some Sata devices, might have been in teh bios actually. Never had any issues with my SSD though. The board i have has a couple of MArvell and the rest are i dunno what

Sneakze · 16 Dec 2013 at 19:41

Ah right, fair enough. Might run a memtest tomorrow, just to tick that off that list.

Sneakze · 19 Dec 2013 at 19:18

Just got a 0124x error, which appears to be not enough vcore on the cpu. Even though i'm running stock speeds?!

wazza300 · 19 Dec 2013 at 19:22

yeah 124 is not enough cpu v,can also be imc voltage but mainly cpu

try level higher llc?

Sneakze · 19 Dec 2013 at 19:34

What would you advise to set it to?

wazza300 · 19 Dec 2013 at 19:37

try low,if unstable set to medium

Sneakze · 19 Dec 2013 at 20:26

Ok, i'll give this a go and see how it does.