Fenix MS1.1 ***PC Desk Scratch Build*** by Marco

[FenixMS1.1]

Update 9 - Side Panels

Hi Everyone

Ok, let's try to get this back on track!!!

Time to start with the fabrication of the side panels, requires a lot of patience as it is made from many different sized aluminium profiles stuck to each other, to a certain degree they look like heatsinks when I look at them from above.

Hope you enjoy.

and in place!!!

Moving on to another area...

at the same time decided to open the holes for the bitspower pass throughs. These were done on the centre back plate...

Hmmm, starting to take on a bit of shape. I think I'm liking it!

 

[R-evans]

Looking good.

 

[FenixMS1.1]

Looking good.

Cheers mate

 

[FenixMS1.1]

Update 10 - The back of the case

Hi Everyone

Sorry for the long time since the last post but have been extremely busy with work.

On this update I will be showing you how I have done the panel for the back of the case. Hope you like it!!!

It all start with another big piece of aluminium and some grills for measurements.

Time to get cutting!!!

Wish it was this quick in real life...

Also finished the inner middle back panel

Back plate all sanded and ready to go...

Had never seen the case from this angle. Quite like it like this

Fitting the grills after completing the riveting

Quite a lot of room at the back for the power supplies, rads and so on

Hummmm, what's next???

 

[Blame]

That is looking very cool! i love these custom desk builds. loving those side panels! very original!

 

[Gunda]

Looking good!! time for more updates !