First go at over clocking

[robwigan]

I have always been afraid to try it but as I'm going to upgrade soon I thought what the hell.

i have an ancient z97 gigabyte mb 8gb 1300mz ram and a 2060

i have played around in bios and set it to 4.3 and got a cinebench score of 1530 with max temp of 73.

I tried to push my multiplayer over to 4.6 and it wouldn't boot so is that a decent improvement or should I just leave it at stock?

I havent touched any voltages I just followed a basic how to guide on you tube that told me to change my multiplier and disable some other settings by the way

my cooler is a double fan raijintek from about 6 years ago that barely fit in my case the thing is ugly and huge so should keep temps down but I'm unsure how to push it further

 

[robwigan]

You haven't stayed what your CPU is but generally, try to increase clock speed in 100MHz steps. If 4.3GHz works and 4.6GHz doesn't, try 4.4 or 4.5.

Monitor voltage while you do this, not just in BIOS but actual readings from HWinfo or similar. When things get unstable, you can either lower the clock speed or raise core voltage. Probably best to stay below 1.3V until you've started fine tuning.

i54670k

so should I be playing with voltage? or just increasing.clock speed in 100mhz increments in the bios till I find a stable level

 

[robwigan]

Setting the voltage manually is safer than letting the board decide as latter method tends to pump more Vcore than needed.

The terms vary depending on manufacturer but you want to choose Manual/Fixed instead of Adaptive/Dynamic (for now anyway) to lock down the Vcore to what you set it, otherwise programs with AVX will use 0.1v extra.

Then just choose a Vcore like 1.3v as Lucky recommended since you have a big cooler. And then continue from 4.4GHz up in 100MHz increments, yes, checking for stability and temps each time.

Is it Cinebench R20 you're using? Try stay 80C or below as that'd be a realistic max temp for a 24/7 overclock.

I dont really understand the top part of your post should I just go back to default instead of messing with voltages I dont feel confident doing that. Over clocking seemed easy when I was just upping the hz.

And yes that was in cinebench r20