Ok took some pics.
https://ibb.co/b3HV5Rh
Not much of a photographer or used to uploading pics so I hope I did not break the forum.
The major issue I am having is to route from the fitting closest to the distro plate to the distro plate. I have a 60mm Alphacool Nexxos rad and it fits beautifully but the clearances for fitting are really tight and I had to remove it and then the fans to even get fittings on the rad and I am going to have to remove some plastic from the Lian Li fans to be able to screw them in.
https://ibb.co/CQNThbC
That pic is a mix of Corsair 90 degree fitting , 2 x Alphacool 16mm HTC and EK 14mm offset fitting. If I got a 34mm male to male fitting i should be able to make it connect. I am really struggling with that connection and until that is done nothing else can be started.
Thoughts I am having.
1-Buy some small soft tube fittings and just do that link in soft tube. I would be looking at it all the darn time so that is the last resort.
2-Look for different fittings till I can make it work. I think I can make all fittings link with a 34mm male to male extender, will look at how to make that work and may have to look elsewhere.
3- Rethink the route and go from close fitting down to lower port near the pump. This would mean half the distro plate is not in use.
4- Get drunk.
For your own build you have to decide on what rads you want and whether to go hard or soft tubing. Whether you go hard or soft tubing I would recommend small fittings. The EK Quantom Vector has the in and out ports very close and 16mm Alphacool fittings I have to do not fit without adapters so you will have to think what to get.