• Notice regarding image hosts and attachments. See here.

Fixing screw holes?

Associate
Joined
15 Oct 2005
Posts
595
Fixing screw head holes?

I have damaged the head of a screw and I cannot get it out of my gfx.
Is there a way to remove it without damaging the card so I can install a new cooler?
 
Last edited:
Guess that depends on what the head of the screw looks like, and how much depth of head you have to play with?

Got a pic?
 
If you have just mangled the head of the screw you could try get a coping saw onto it and cut a new slot to use a flat headed driver on. You would have to be SUPER careful not to damage the PCB though.
 
Last edited:
I was thinking of breaking the plastic that the current fan sits on and unscrewing it from inside out.
It's funny that the same screwdriver was good for all the other screws except for the last one :(
 
its a tense job on a gtx480, I bought exactly the right screwdriver and even then i had a few hairy moments with one or two screws
 
If it only screws into plastic you could be real ghetto and try putting a soldering iron on the head and melting the plastic around the thread through heat transfer.

You would have to be absolutely sure there was not metal contact though as it would transfer heat to possibly more heat sensitive parts of the card.
 
Where is the screw located? If its on the edge without any connectors near, you could just cut a slot and slide it out?
 
I had a friend who done the same thing, then brought me the card to sort out.

So butchered, I couldn't drill it out, so I got the screw out by super gluing a panel pin to the screw head, then using pliers to grip the nail, it unscrew easily.

might need to let the glue cure for a few hours though, to get full strength.
 
M4BhI.webp


This is it.
 
That's a prime candidate for cutting a slot into and using a flatblade.

Although it looks as if perhaps there might be enough "vertical" of the screw head to potentially use a pair of pliers.
 
Well, I went ahead and ordered the 680 today.
I will probably put the new cooler on the 480 and sell it on the MM, I will try the pliers method first.
 
If you have just mangled the head of the screw you could try get a coping saw onto it and cut a new slot to use a flat headed driver on. You would have to be SUPER careful not to damage the PCB though.
I think you mean a junior hacksaw.A coping saw is for cutting curves in wood,not straight cuts :)
 
Back
Top Bottom