Flow direction using EK Parrel Bridge

Associate
Joined
14 Apr 2010
Posts
430
Location
Milton Keynes
Hi there,

So I was just looking for some clearification on the EK Parrell Bridge

I have a dual bridge hooked up to two ek blocks atm. now the question is..

Does it mater which port you use as and inlet/outlet?


Thanks guys.
 
I think so long as the inlets/outlets are not all lined up you should be good, otherwise the water has a tendancy to flow straight through the bridge and not through the gpu blocks.
 
Found these images by ek, should help. I'd personally go for this
171021.jpg

instead of
171022x.jpg

I don't think in a dual setup it would matter which inlet outlets you use, gpu blocks are not (yet) like cpu blocks that have jet plates and need the center hole to be used as inlet.
 
Last edited:
Back
Top Bottom