• Notice regarding image hosts and attachments. See here.

Front wheel squeeling?

Soldato
Joined
3 May 2012
Posts
11,518
Location
Wetherspoons
Hi guys, little puzzled by this.

My Mrs Fiesta Mk7. Front driver side wheel (pretty sure) squeels quite regularly, sounds like a high pitched squeel, probably metal on metal but not certain. It's pretty loud.

Oddly, does not do it whilst braking, the brakes otherwise work and feel fine, seems to do it when driving more slowly, 30mph or less, with the wheels pointed straight.

I took the wheel off, and the caliper off, and the back pad, just so I get get a good look. Pads looks fine, all evenly worn, brake caliper piston seems to be ok, for 13 year old car with 100k miles.

I cleaned everything up as well as I could, applied copper grease to the caliper where it contacts the back of the pad, a bit of silicone grease around the piston seal, copper grease on the wheel hub, wheel back on, took it for a test drive and was fine.

Now the Mrs is reporting it's back again.

Any ideas what could be causing this? Admittedly I'm not familiar with the noise a wheel bearing failing would make, but from what I've heard it tends to be more of a low pitched droning. Also I didn't feel any movement or wiggling of the wheel when the car was jacked up.
 
Sticking slider causing slight pad contact would be my shout.
Either that or your Mrs just like to say weeeeeeeee
 
Is the dust shield rubbing on the disc? I've just had that on the wifes car as it'd rusted so badly it pretty much collapsed onto the disc so i just pulled it off.

Wheel bearings for me have always been a rumbling or whirring sort of sound not a high pitched squeal
 
I get this on my Abarth when turning left at low speed, but it usually stops once warmed up. I'm not 100% sure what it is but I suspect the brakes as only them vibrating slightly makes a high pitched sound.

Bearings make a loud rumbling noise usually and it's constant.
 
Last edited:
Wheel bearing can make a chirping noise if they are pretty bad, mine would do it when turning at low speed turned out the bearing was very badly worn.
 
I think it must be something making contact with the brakes.

I can't think what else it would be and I did have a good look at everything to see if I could see any rubbing (bright metal colour etc) but nothing outside where the pads contact the discs.

Thing is I'm reasonably confident whatever it is, won't do any damage other than potentially wear some part of the brake unevenly (and again didn't even see evidence of that) but Mrs keeps ******* moaning at me about it, and to be fair, it is pretty loud so somewhat embarrassing to be driving it down the road.

But short of changing the caliper, then probably both sets of discs/pads (and the pads have plenty of meat on them) I don't know what else to do, so what, £250 worth of parts?

Maybe I should lubricate the discs....... :D
 
I have a mk7 ST and getting a similar issue. Sometimes I hear, sometimes I don't. When I do hear it, it's more pronounced at lower speeds but then when I apply the brakes, it stops. I think mine is coming from the left rear wheel.

I think it's probably a sticky slider pin as suggested by Dis86. I had the rear discs, pads and pins replaced a couple of months ago, so surprised I'm getting the issue.

It is common with the Fiesta as the cleaning and regressing of the pins are always neglected when pads are replaced.
 
IMO you should remove the wheel and caliper again. If you cannot press the caliper piston(s) slowly back into the caliper body with firm pressure from two thumbs, the pistons are sticking. Just as likely rust inside the lip(s) of the caliper body as rust on the piston(s).

If the slider pins on which the abortion that are sliding calipers, err, slide, are not totally free and slide in and out with totally minimal effort, they are seizing. If they are at all sticky being pushed and pulled in and out of the casting with no thrust loads on them from braking torque, they'll be really bad in operation.

IMO the best grease for them is branded, molybdenum disulphide grease, commonly used in the type of constant velocity joints that use ball bearings as the torque transmission medium. NOT the ones with rollers on needle bearings. The stuff that comes in little sachets is usually junk at high temperatures and it dries out. The good stuff ain't cheap, in fact you can spend a lot on good greases : https://www.autosport-bearings.co.u...synthetic-high-performance-calcium-complex-2/ Not that you stuff like Neo lubricants for this job :)

Other possibilities are the pads have wear indicator tabs that are actually designed to squeal when they contact the friction area of the disc, when the friction surfaces get to a thin level, but you seem au fait enough with pads to have noticed this, or as I think someone previously mentioned, the disc backing plate is bent and occasionally contacting the disk, or it maybe has a foreign body trapped within. It could be wheel bearing related, is the hub flange nut fully torques? Any signs of rust dust around the nut to flange interface?

HTH and good luck. I am finished with work related topics for today now. :)
 
Thanks.

Well, I took the car about today, probably 10 miles mix of country road, little bit of town, putting heat into the brakes etc.

Literally nothing, no squeeling, no vibrations through the steering wheel, even smooth braking...... everything fine.

Get home, report that, and now she's having a go at me because she thinks I thinks she's making it all up. Can't win....

I reckon there is nothing wrong with the car personally other than the fact it's a 13 year old 100k 1.4 petrol Fiesta and the normal associated.
 
Bear in mind, like the need for wetting a finger to the correct degree and applying JUST the right preesure with it on the rim of a wine glass, to make it "sing", such are the peccadilloes of a singing brake disc excited by a rubbing pad. Weather, or even humidity can make a difference. The same applies with squeally auxiliary belts.

Don't send her to the spare room just yet, but have her get the bed ready... ;)
 
Back
Top Bottom