FSB Reset

SoundEng · 26 Aug 2008 at 17:22

Hi

i had my Q6600 running at 3115Mhz @1.39v i was running core temp when i noticed it was only running at 2400Mhz i restarted and entered the bios the voltages were still the same but the clock frequencies had been reset i changed them back to the values i wanted and saved and exited the bios when it rebooted i entered the bios and the voltages were the same but the clock frequencies had been reset again. :confused:

i have reset the cmos and it has made no difference i am running on a striker 2 formula

any suggestions?

thanks

SoundEng · 26 Aug 2008 at 21:12

Please help thanks

SoundEng · 27 Aug 2008 at 09:25

now when i try to boot into widows with the clock frequencies overclocked it says boot failed

SoundEng · 27 Aug 2008 at 09:31

please i need to overclock

Pneumonic · 27 Aug 2008 at 10:03

what BIOS verson?

SoundEng · 27 Aug 2008 at 20:16

dunno how do i check?

RJC · 27 Aug 2008 at 21:56

It should show on startup.

Try lowering your overclock and see how that goes, it could be an unstable overclock.

RaV · 27 Aug 2008 at 22:00

It sounds like an unstable clock, What motherboard are you using? try lowering the clock a good bit to see if its that, if it boots you can then put up the FSB a bit at a time until you get problems, and then lower it back down to the work values. or loosening the ram timings.

SoundEng · 28 Aug 2008 at 14:14

cheers

SoundEng · 28 Aug 2008 at 14:15

i only tried to raize the fsb by 5 mhz