16 Jan 2012 at 14:21 #1 Gimpymoo Gimpymoo Soldato Joined 31 May 2005 Posts 15,640 Location Nottingham STUPID QUESTION ALERT. Just came to setup my G25 on a desk it has not been used on before and the clamp is too small. I notice there is a cap on the end of each clamp, how do I remove this? Thanks.
STUPID QUESTION ALERT. Just came to setup my G25 on a desk it has not been used on before and the clamp is too small. I notice there is a cap on the end of each clamp, how do I remove this? Thanks.
16 Jan 2012 at 14:32 #2 barmyllama barmyllama Man of Honour Joined 20 Dec 2004 Posts 7,370 Location Tamworth Just slide them off.
16 Jan 2012 at 14:36 #3 Gimpymoo Gimpymoo Soldato OP Joined 31 May 2005 Posts 15,640 Location Nottingham Thanks. I wasnt sure which way they came off and needed to apply pressure but was not sure which way. They popped off sliding away from the wheel.
Thanks. I wasnt sure which way they came off and needed to apply pressure but was not sure which way. They popped off sliding away from the wheel.
