Ok. Here's my H500M:
Thanks. I have two types of rattle, one that is at all times but you either need to be in a rather silent room or put your ear up against the fan to hear it. The other starts and stops which is much louder rattle. If the later stopped I could live with the former I suppose.
Super. Going to do the same
I have not tried but I on the review the guy says that they can be pwm and can get the mono to control them. On dc on low setting I would not say they are whisper quiet but you mainly hear the air being pushed (unless you get rattle like my fans). On my last case I had my fans hooked to mono and they were on lower rpm when browsing, you literally could not hear them unless you put your ear near the case.
Did you miss mr1000’s post?
Ah fair enough, it did not occur to me that was your case. Thought it was some random link from youtube, my badNo but I wanted to show off my handy work
I think a single colour strip might be better. It shouldn't take away from the fans as much.
On that slippery slope.... AIO cooler next.... well, that big hunk of metal just spoils the look doesn't it?
Looking at 240mm rads, case supports up to 360, but only in the front. I want to mount to the top, so 240 is the official limit. (Though in this vid he suggests a standard depth 280 should also fit...)
I have installed the ARGB LED Strip that I ordered recently and I think you may have a point, it can be a little distracting having them on at times and it does seem to detract from the fans. Maybe I just need to get used to it. Will leave it like this, but if it does not sit well with me eventually I may put the ARGB strip to the top and put the RGB strip to the bottom.
That does look interesting. Might give it a go
Nice. What else you plan on doing?AIO arrived today, really easy to install. (Before and after):
Temps look really good, currently sitting at 24 degrees idle and all I can hear is the case fans.
In my opinion yes. But I do not know of every single case, but this was the first case I saw that made me want to change my case.
It should, but might be a tight fit. Check out mike’s unboxing guys videos he has one that mentions this I think, it is in a q&a type video about the case.Hi guys, would this case fit a Arctic Freezer II 280mm AIO?
Try:
a) mounting the fans with rubber gromits against the screws
b) Folding a small piece of paper (as many times as needed until it's thick enough) and pushing it under the fan to really press it tight against the case mounting to reduce any looseness that may cause rattling.
Pretty sure he said one at the bottom (the third one) was not magnetic. Nothing about there only being one magnetic.
Try reseating the sata power cable. Mine is very picky and does not make contact if not pressed in properly or at the right angle.
Yep, needs to be connected to mobo to control. I have not done it myself, i just use the remote.
Pretty much my thoughts also. Not the best fans in terms of acoustics, but otherwise for the money it really is a great case.
Not used mine. But all you will need is the riser cable.
