GPU Power Limit Mod

[xTommy92]

Hi Guys,
Just decided to do a complete new driver re-install and due to that I have lost my Power Limit Mod. Weird thing is since I have re-installed my Registry it looks a little different. I checked Tommy's thread again but it looks different so before I did anything I wanted some advice.

I have already changed the 14 to a 32 in the Phm Powertable and Merged it but when it comes to the second GPU it is a little strange.
As you can see in the below image, both GPU's have 'Adaptive Desc=' in a different place:

 

[xTommy92]

Anyone?
This is really confusing right now.

Tom

 

[tommybhoy]

Doubt many will be able to answer it, better sticking to the thread tbh.

To answer your question though, you add 'Phm Powertable' values straight after 'Adaptive Desc=' in the second table.

You should keep those reg entries handy after you mod them(save each copy) as you will need them each time you change/clean drivers, then it's a simpler case of install drivers>increase CCC limits via AB hack>merge reg entries>restart.

 

[LtMatt]

Or you could just flash a bios and never have to do the hack ever again.

 

[xTommy92]

Thanks guys, seem to have sorted it.
Also when I start the PC up and go straight into iTurbo and load up my saved OC Profile the voltage on my Twin Frozr maxes at 1.199v but the Ice-Q sits at 1.200v. As soon as I select the Ice-Q and change the voltage to 1.250v the Twin Frozr changes to 1.250v, does that sounds okay to you?
I have Afterburner up as an overlay and the voltages and clocks seem to be going good, just don't want anything happening that I cannot see like both of them working at different voltages but not being picked up in the overlay.

Tom

 

[LtMatt]

All you can do is go by the overlay or gpu-z. If they report it as fine then it should be ok.

 

[xTommy92]

GPU-Z is reporting the same voltages and clocks.

Tom

 

[tommybhoy]

Thanks guys, seem to have sorted it.
Also when I start the PC up and go straight into iTurbo and load up my saved OC Profile the voltage on my Twin Frozr maxes at 1.199v but the Ice-Q sits at 1.200v. As soon as I select the Ice-Q and change the voltage to 1.250v the Twin Frozr changes to 1.250v, does that sounds okay to you?
I have Afterburner up as an overlay and the voltages and clocks seem to be going good, just don't want anything happening that I cannot see like both of them working at different voltages but not being picked up in the overlay.

Tom

That's why I never kept the TF and matched my IceQ, couldn't be bothered with the hassles, but might have kept it for the savings if bios modding was possible back then.

You have your cards now and with bios modding being simple(really it is) what I would definitely do in your shoes would be to flash a 1.175v bios to the IceQ, everything would be more simpler for you.