Associate
Hi guys, after some advice once again.
Just tried bending petg for the first time today (xspc pipe and rubber), it all went fine till i tried to remove the rubber. It would just not budge, it was a 180 degree bend though and i dipped the rubber in fairy liquid water. Any advice on what I could be doing wrong? Heating the pipe too much, should I be removing it while still warm?
Anyways, any of your input would be greatly appreciated (i have more rubbers on order).
Just tried bending petg for the first time today (xspc pipe and rubber), it all went fine till i tried to remove the rubber. It would just not budge, it was a 180 degree bend though and i dipped the rubber in fairy liquid water. Any advice on what I could be doing wrong? Heating the pipe too much, should I be removing it while still warm?
Anyways, any of your input would be greatly appreciated (i have more rubbers on order).