Hitachi feature tool "unhandled exception"

joeyjojo · 20 Mar 2006 at 23:23

Hi
I have two hitachi deskstar 7k80 drives in raid0. System is opteron 148, dfi lanparty expert, windows x64.

I downloaded the iso for hitachi feature tools to enable 3gb/s on my drives, burnt the disc and booted from it. It loads dos and mouse drivers etc, then says "unhandled exception", followed by some error numbers. It also mentions rtm.exe, which seems to be to do with memory managment.

The cd works fine in my athlon xp system (no serial ata unfortunately). This seems to be an unusual problem so I'm not expecting much. Any ideas? anybody seen a similar issue? Thanks

joeyjojo · 21 Mar 2006 at 17:57

jonnyg - I thought the same thing, it's still a mystery though...

Everything is fine now, both set to 3gbps!

The tool loaded after a few tries. It was slow to navigate but I eventually set both drives to 3gbps. Given a 1MB/s increase in sustained read, massive increase in burst speed. A must for hitachi drive owners

joeyjojo · 21 Mar 2006 at 22:53

400? Well lah dee dah

(...must force more performance out of those drives)

Thats that 4 disk raid0+1 array right?

joeyjojo · 21 Mar 2006 at 23:19

smids said:
Yes, but will perform as your setup...

...in theory

So where's my missing 60MB/s burst? I want that 60MB/s back

Seriously why is that? I'm just usin the sata on my mobo (lanparty expert) ie no fancy raid card. I assume you are aswell from the "nvidia" in the screenie

joeyjojo · 21 Mar 2006 at 23:33

smids said:
RAID1 increases read ever so slightly because it can read the same data from either mirror hence the slightly increased read.

Thats what I thought

smids said:
but will perform as your setup

That had me confused