how much rad space?

[doggles]

hi,

I currently have an i7 920 oc'd to 3.6 and an ati 6990
card with a full block. these currently are cooled with a 480 & a 240 rad all on the same loop.

this is all inside a tj07 case with both rads in the bottom, however it's a tight squeeze and the psu unit hangs out the back as there isn't sufficient space to screw it in place. this doesn't really bother me too much but I was thinking if I changed the 240 rad for a single 120 I would be able to get the psu in easily.

so would I see much temperature change by doing this?

I run the fans very low so I can't hear them with the coolants temp not going about 39oc

 

[no_1_dave]

You don't need anything more then 120.3 with your setup.

 

[cobbly123]

i dont think you would notice a lot of difference with temps as said ^ a 360 would cope fine.

 

[doggles]

thanks guys

 

[JeffyB]

Just ditch the 240 and you'll have plenty of space for the psu. You could also run the 480 in push pull to make up for the lost capacity, leaving the last 1 or 2 fans off to allow room for the psu.