IP Camera setup help

YoungBlood · 15 Nov 2011 at 10:10

Im trying to setup an IP camera using my static IP address.
With it being static I thought it would be quite easy, but along with a lot of other people, I can't view the stream from outside my own network.

Here is a shot of what the camera is complaining about.
It says that my subnet mast address does not match when as you can see, they do.

Any suggestion welcome.

I have also set the cam to use port 85, so would this be the corect setting in the port forwarding page of the router?

Then to view the cam it would be "my IP":10123

YoungBlood · 15 Nov 2011 at 10:21

Thats the setting box that pops up when u double click the error message, with IP address removed.

YoungBlood · 15 Nov 2011 at 10:27

If i set the gate was as the router address it tells me that gateway setting is illegal.

YoungBlood · 15 Nov 2011 at 10:31

Its starting to make sense.

YoungBlood · 15 Nov 2011 at 10:39

So what numbers should be in the gateway setting?

YoungBlood · 15 Nov 2011 at 12:18

Thanks, I'll give those a try tomorrow, I ran out of time for today.

YoungBlood · 17 Nov 2011 at 12:26

The camera is now viewable from outside my network, however I can only access the camera from outside when im using the network cable.

When I remove the network cable from the camera, the wireless takes over fine and it does stream images within my network, but the same address that I use to view the cam "my ip": port number does not work under wireless.

Any suggestions?

YoungBlood · 18 Nov 2011 at 13:46

Would anything there be causing the problem? Thats as detailed as the firewall gets.