Associate
Hi All,
I know the subject has been raised many times before (mainly in reddit forums) so i shan't waffle on about the incentive for doing this. Fact of the matter is that CAM software is terrible and has never worked for me.
Does anyone know if it has ever been attempted to remove (or just bypass) the control board in the kraken unit and wire the pump directly to a motherboard header? thus giving full control over pump speed/RPM directly to the BIOS.
My hope is that this would allow me to raise the pump speed over 2400RPM when needed.
I know the subject has been raised many times before (mainly in reddit forums) so i shan't waffle on about the incentive for doing this. Fact of the matter is that CAM software is terrible and has never worked for me.
Does anyone know if it has ever been attempted to remove (or just bypass) the control board in the kraken unit and wire the pump directly to a motherboard header? thus giving full control over pump speed/RPM directly to the BIOS.
My hope is that this would allow me to raise the pump speed over 2400RPM when needed.