Lexibug !

He certainly has superb fabrications skills, just a shame he doesn't appear to have the engineering knowledge to back it up. That is the worst front suspension design I have ever seen. And it must weigh a silly amount, he's gone a bit OTT with the 3mm and 1.6mm plate.
 
Last edited:
I can't stop grinning at the photos of the body suspended between the camper fan, a pair of step ladders, a workbench and a bending bar, lmao - quality bodging :)
 
I would love the space and tools to do things like this. Even if I bugger it all up and am not as good as that, I'd love the oppertunity. I say this a lot, I best start working hard and stop being useless!
 
Just finished reading the whole thread, I lost an hour.. hah

Can't wait to see if perfectly finished :cool:
 
Good skills, but so far I'm a little surprised by the drilling through at the welds on the front cross member (the 26mm dia. holes). Not sure if there would be clearance issues later on (only on first page), but for the sake of an extra kilo, I'd have had the uprights on the cross member at 90 deg. and drilled through plain, unwelded box section.
 
Back
Top Bottom