LTO Tape Drives and software

I assume the connection to the drive is differential scsi? have you got the correct card/terminator/cable?

If so is the card set to differential 160/320 or single ended?
 
The scsi card is an Adaptec Ultra 160 SCSI pci card.

It has 2 internal connectors -> SE Segment and LVD/SE Segment.

I am using the LVD/SE Segment.


The drive is a Freecom/HP tape drive with a Ultra 160 LVD scsi connection (Ultra3).

I am using the cable that came with it. It has 4 connections on it.

1. Connected the scsi card.
2. Empty.
3. Connected to Tape drive.
4. Termination block (already installed on cable- Block says SCSI LVD 320).


I am reading through the different manuals just now....
 
Last edited:
There is a jumper on 2 pins which is labled 'TERM POWER'. Has this got something to do with termination? I have not found anything in the manual about it.
 
Last edited:
I am heading back from Jersey just now. I have been working there for a week.

Any one got and idea why I am not getting the speed? :(
 
I am back now and no replies... everyone hates me :(

I think I will go out and clean my car :)

On a serious note :rolleyes:

Please... if anyone has any ideas I would be very grateful.

Thanks

crazyswede
 
You must log in or register to reply here.
Back
Top Bottom