• Notice regarding image hosts and attachments. See here.

Mountain Biking

Well, by the sounds of it it may be a part swap out, when you had the fork tuned what did it entail? Fingers crossed you’re golden?
I’ve had a WPS piston kit fitted. New main piston, shim stack and ifp spring.

Hopefully I can get jtech to do any warranty work as they time them for me.

Booked my spare 38’s in for a service and a new steerer so I can use them in the meantime.
 
I’ve had a WPS piston kit fitted. New main piston, shim stack and ifp spring.

Hopefully I can get jtech to do any warranty work as they time them for me.

Booked my spare 38’s in for a service and a new steerer so I can use them in the meantime.
Joys of the spare parts bin eh! I’m getting my Zeb serviced so it can be thrown on when I need to get the Dorado done. I don’t really fancy using my spare 160 36 in its place, it’ll feel a bit weird.

Once the WPS kit was installed and the fork set up how did it feel?
 
Fork has felt good.

Used it at the FOD mini enduro and done a few off piste bits and bobs.

J-tech said they can handle any SRAM warranty stuff so should be all good.
 
I have been using squirt for a while. It lasts for ages but not so good when it is extremely went and gritty, though you can just add it on top.
I meant immersion waxing. Still using Tru-Tension BananaSlip Tungsten in between, but loving how clean it keeps everything, that alone will probably pay for itself. All the data seems to point to clean and low lube is better than dirty and lots of lube.

Ordered some supplies for re-lacing my rear wheel got some brass Sapim Polyax 14mm and a little tool for poking them through the rim without dropping them inside and some boiled linseed oil.

Got a big ride planned next weekend, setting off from Llangollen and doing Worlds End and the half decent bits of Llandegla.
 
Last edited:
Have you used both the wet and dry versions of BananaSlip? Will need some more lube soon and was considering giving it a try.
As far as I know there's only one version of this one. It's specifically listed as a suitable top up to immersion waxed chains.
 
Last edited:
How are you getting on with the waxed chain in mud ? I tried it before and it wasn't great but think I need revisit it. I am sick of cleaning the current chain after every ride with a chain cleaning tool, needs the bike on a stand as I can't spin the chain backwards.

Does seem to be lasting well though on 600 miles ish and still no measurable wear so recon the 1000-1500miles per chain is about right which isn't too bad got a couple spare cheap from Merlin so hoping I'll get 4500miles ish out the cassette/3 chains.
 
Last edited:
How are you getting on with the waxed chain in mud ? I tried it before and it wasn't great but think I need revisit it. I am sick of cleaning the current chain after every ride with a chain cleaning tool, needs the bike on a stand as I can't spin the chain backwards.

Does seem to be lasting well though on 600 miles ish and still no measurable wear so recon the 1000-1500miles per chain is about right which isn't too bad got a couple spare cheap from Merlin so hoping I'll get 4500miles ish out the cassette/3 chains.
Fine I have two chains per bike now and swap them every few rides. If it's dry I do nothing if it was wet I add some of the previous mentioned TruTension Tungsten All weather. Not needed to clean the drivetrain since. Rewaxing takes no time at all as it's doing its thing while I'm cleaning everything else.
 
Back
Top Bottom