My first conroe:overclock sudgestions...

the ram trimings can have an effect on required voltage yeah. but by default my corsair pc6400 runs at 5-5-5-15 1.8v but corsair state it will run fine at 4-4-4-12 2.1v so i put it at that. i was also reading an article other day about overclocking a 6700 on the max board and it ran stable at 340 with no voltage changes.
 
well that is interesting because..

I just tried a 330 and 355 *9 clock with

1.6v mch/pci

2.2v DDR2 running at bios 450 /ddr2800

4-4-4-12 timings

and neither would boot past error codes 52 and 50 respectivley....

:( so not sure what going on....

cheers,

James.

p.s i clocked to 300*9 no voltage changes timings 5-5-5-15 / and those 2 options what were they EIST? and CIE or something disabled and it booted fine, although tidle temps are 40c where as when i had the clock at 299*9 before i tried higher cocks the temps were 37-38c...

anymore ideas or things to try would be gratefull...
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom