New built pc wont turn on....

theFSB

theFSB

theFSB

Permabanned
Joined
18 May 2006
Posts
23
Guys,

Just built my new system, all brand new parts etc.

Intel Pentium 4 950 Dual Core "LGA775 Presler" 3.4GHz

Asus P5WD2 Premium Intel 955X (LGA775) PCI-Express Motherboard

Patriot Low Latency 1GB (2x512MB) PC5300 667MHz DDR2 Dual Channel Kit

my current GFX card is the Sapphire ATi Radeon X1900XT-X 512MB which i am obviously keeping.

PSU - Enermax Liberty 620W

Now then, i rig it all up and when i power on everything spins up, but i get no monitor output, I have tried and tested everything I can, and have narrowed it down to the CPU or Mobo (as its unlikely to be RAM)

Tested GFX Cards, Reset CMOS etc.

Its either Mobo, CPU or RAM causing it. As they are the only untested components...

Anyone got any advice or ideas?

Thanks,

FSB
 
This may be a clue -

When you power on the Radeon X1900XT-X as you may know, the Fan spins full speed for around 10 seconds before slowing down.....

Well, when I switch this one on, it doesnt slow down and continues to spin full speed until you cut the power. Have tried this with an X800 to verify the X1900 isnt faulty and it does the same thing.

Anyone have any ideas?
 
Mul said:
Surely if the motherboard was being shorted, it wouldn't power up at all?

Do you have the ATX12V Cable, 24pin ATX Cable and 4 Pin molex plugged into the P5WD2 Premium? Stupid question but it's worth a try.

Mul
Click to expand...

Yes mate, its all where it should be :(
 
Mul said:
ugh gutted. Thought I'd check as I'd initially forgot to plug in a molex into my DFI board. :o

Tried each stick of RAM independantly?

Mul
Click to expand...

Thats the 1 thing i havent tried......

You think its that? :eek:
 
Just tried PSU, Mobo, GFX, CPU and RAM on thier own

roatated the RAM sticks and tried both on thier own....

same thing still happens....

Now I doubt its the RAM so getting new mobo tomorrow to try....

:(
 
You must log in or register to reply here.
Back
Top Bottom