• Notice regarding image hosts and attachments. See here.

new crossfire setup and shutdowns

Associate
Joined
26 Oct 2002
Posts
1,066
Location
Corby Glenn
Hi guys

just got another 4870 and the system booted up fine, installed ccc and it detected both cards straight away.

i started to run the clear skies bench to make sure they were both working and within 10 seconds the system restarted.

tried it again with the same result.

changed the xfire bridge to the other 'socket' and still the same.

so lastly i fired up cod waw and that crashed within 2 secs of getting 'in game'.

i have had to use the 4 pin to 6 pin adapters 'cos my power supply only has 2.

my feeling is its my psu.

what do you lot think?

and should i try xfiring without an overclock?
 
i know you say you changed the bridge to the other 'socket' but i have two crossfire bridges installed on my 4850`s and my system has never crashed due to graphics
________
Yamaha Diversion
 
Last edited:
it's a 580w one.

i have gpu-z that i can check with but i think they idle at around 75 degrees ish.

also i only have 1 bridge that came with my existing card. didn't get one with my new one.
should i be using 2 of them?

Jobe
 
Idle that's quite high... graphics cards can handle higher temps than CPUs but it might be going stupidly high. Run it at the same time as a game as GPU-Z and see what the temps are when it crashes. Also, could it not just be a problem with the game?
 
I also have 2 x Crossfire bridges fitted to my system (4850's) but my PSU is a 650w, i also think it might have more to do with your PSU personally.
 
does anyone else have a crossfire setup with only 1 bridge fitted?

jobe

oh and they're idling at around 69degrees
ran furmark for 5 minutes and they reached 92degrees
 
Last edited:
i have 2x 4850's in crossfire and only one bridge fitted (closest to the back of the card).

i had a problem like your having and it turned out to be my new driver's.

i uninstalled the new one's and went back a few and everything is lovely now.
 
thanks mate.
i uninstalled all drivers and installed them again when i fitted the new card.

looks like i might have sorted it.:)

my psu has a switch at the back, combined and seperate.

i switched it to combined and it seems to be running ok now, just done a run of clear skies which the new scores seem to confirm xfire is working.

thanks all for your help:D

Jobe
 
Back
Top Bottom