Ok, so today i built my friends new PC and it was all installed properly and i have 3 possible problems, but the main one was whenever we turned on the PC the fans turned on and all no problems etc.
But when we plugged it into the Monitor (32" TV) there was no display just a blue display screen saying no signal detected, now would this be caused by any of the following problems being that;
1. Im using 3 Memory Sticks on a Dual Channel Board?
2. The power connectors from the case to the motherboard may not be in the right configuration.
3. The ATX 24 Pin plug isn't fully plugged into the board.
Ok so ill elaborate on #3 basically the ATX plug isnt fully clipped into the board as it doesnt seem to go fully in, it will go about 9/10ths in but it wont click in place, i dont see how this could be an issue as its near enough in but im just wondering for any possible errors.
Heres the specs for interest.
Asrock B75 Pro3-M
Intel i3 2220
Kingston 2GB Ram x 3
1TB WD HDD
500W CORSAIR CX SERIES PSU
Aerocool Strike X Case
But when we plugged it into the Monitor (32" TV) there was no display just a blue display screen saying no signal detected, now would this be caused by any of the following problems being that;
1. Im using 3 Memory Sticks on a Dual Channel Board?
2. The power connectors from the case to the motherboard may not be in the right configuration.
3. The ATX 24 Pin plug isn't fully plugged into the board.
Ok so ill elaborate on #3 basically the ATX plug isnt fully clipped into the board as it doesnt seem to go fully in, it will go about 9/10ths in but it wont click in place, i dont see how this could be an issue as its near enough in but im just wondering for any possible errors.
Heres the specs for interest.
Asrock B75 Pro3-M
Intel i3 2220
Kingston 2GB Ram x 3
1TB WD HDD
500W CORSAIR CX SERIES PSU
Aerocool Strike X Case
