• Notice regarding image hosts and attachments. See here.

New SSD Speed Problems

Permabanned
Joined
13 May 2011
Posts
258
Just got a new 60gb Agility 3. Since all my old data is on a 1tb raid 0 setup I kept it in RAID mode so I didnt loose all my data.

After this I sometimes cant boot and I bluescreen sometimes when im in windows startup. But when im in windows all is fine and the system is stable. However just run ssd tests and in AS SSD benchmark im getting 170mb read and write which is terrible for my SSD my old RAID 0 is getting 240MB/s read and write.

Should I backup my data and do to AHCI mode Ive read that its faster, also OCZ firmware update is not detecting my SSD is this to do with the RAID mode?

Thanks Liam
 
I know WEI is a load of crap but with AHCI i now get 7.4 with RAID i only got 7.2 and IDE only 6.9. Someone give me a good program to benchmark my ssd
 
You mentioned that the firmware updater is not recognising your drive

If you have windows on the drive you are trying to update, you need to boot from a USB stick using software on the OCZ site, you cannot use the toolbox

Hope this helps :)
 
resultsz.png


results from atto
 
Laim, you've answered your own problem in the 1st post!

Your running the drive in a RAID system, thats the 1st problem!

Use on main SATA port, INTEL or AMD not any other
AHCI
2.15FW min
FRESH INSTALL

Thats it. Bench with ATTO nothing else!
 
my motherboard only has sata 3 slots 'SATA3 - 5 x SATA3 6.0 Gb/s connectors, support RAID (RAID 0, RAID 1, RAID 0+1 and RAID 5), NCQ, AHCI and "Hot Plug" functions' and i am running ahci with it enabled in windows registry

Not sure about the cable though does it actually matter? Im using the cables but on the motherboard website it doesnt say what type sata they are..
 
Last edited:
no cable doesnt matter
just had a look at your board and as you say it has 5 x sata3 ports, clutching at straws but have you tried another sata3 port? when you did your install did you have achi enabled?
 
no I couldnt install it with in no drives were found When I got in I changed the registry settings and the bios to AHCI and this took my WEI score from 6.9 to 7.4.. not sure whats going on here
 
no I couldnt install it with in no drives were found When I got in I changed the registry settings and the bios to AHCI and this took my WEI score from 6.9 to 7.4.. not sure whats going on here

now your in windows and have formatted the drive it will see it now so maybe do a fresh install this time with achi enabled first as it sounds like something in the registry is possibley screwed up
 
Back
Top Bottom