• Notice regarding image hosts and attachments. See here.

New Vista install BSODs - help?

Associate
Joined
26 Jan 2007
Posts
43
Hi All,

I've just completed a new build with the specs below, and am getting seemingly random BSODs. The first one happened during the Vista install. It was busy reading and extracting the Vista files from the CD and BSOD'd. It hadnt completed the setup, and there were no 3rd party software drivers loaded at that stage.

So I restarted, reformatted the HD, ran the Vista install and this time forced selection of the SATA ICH9 driver from the ABIT driver disk (vista didnt seem to want to accept any of the listed drivers as compatible so I guessed this might be the most suitable). But it seemed to work. Vista installed and seems to run fine. (btw I have no plans for RAID)

So I got on with loading further drivers (e.g. Nvidia and Windows updates etc etc)

But I'm finding the BSOD's are still occuring every hour or two.

I'm starting to wonder whether there might be a SATA driver issue as Vista didnt seem to recognise Intel ICH9 driver supplied as being a compatible option, or whether perhaps my GEIL memory is incompatible with the ABIT IP35-E.

Any ideas out there?

J

Abit IP35-e
E6600
OcUK 8800GTX
GeIL 2GB (2x1GB) PC6400C4 800MHz Ultra Low Latency DDR2 Dual Channel Kit
Samsung SpinPoint T HD501LJ 500GB SATA-II 16MB Cache
Corsair HX 520W ATX2.2 Modular SLI Compliant PSU
Creative Sound Blaster X-Fi Xtreme Music 7.1 Soundcard
 
Make sure you have set your memory timings, so go into the BIOS and find the Memory section.

CAS - 4
tRCD - 4
tRPD - 4
tRAS - 12 and set the memory to 2.2 Volts.

You have to make sure you set the right timings otherwise their will be BSOD every so often (Most likely cause anyway) ;) If it still happens then run Memtest and if your getting errors RMA your Memory my friend.
 
Last edited:
Thanks Invader.

BIOS installed seems to be latest and matches both version on CD and latest on ABIT.tw.com site.

But I havent tried Memtest yet.
 
stickroad, my memory voltage default was at 1.8v. I've now set it to 2.2v. Seems a big jump. Could the lower voltage have been the sole cause?
 
Back
Top Bottom