O11 Dynamic Evo XL - Specific Question for Owners

Freegrazer

Freegrazer

Freegrazer

Associate
Joined
3 May 2013
Posts
145
Location
Ireland
Very quick question about this case, hoping someone can answer it for me plz - what is the vertical distance between the 2 drive cages?

Can't seem to find this detail in the specs or the manual.
 
You're welcome mate
Noticed it in there and would have been tempted by it
If it had been the white version
but black or white should still be same dimensions

He may have packaged it up already for posting
Or may not as some one might want to
Collect in person and see it
But can't hurt to ask
Worst can happen is he's unable to do it
 
Yep, defo no harm asking. And no biggie if he can't do it.

It's a beautiful case in either black or white, and so versatile with lots of options to suit my needs. Really like the reverse build option as my PC sits to my left with no room on my right.

I already got a PSU and just want to be certain I can fit it without removing the 2 drive cages. I think I'm being a little overly cautious as most of the PSUs I've looked at seem to be around 150mm in width so the same as the one I got and so should be absolutely fine to fit. But I just don't want to buy the case and then find out it won't fit! Nothing worse than starting a new build and then having to stop and go search for a suitable alternative part and order it and wait for delivery. I want it NOW...
 
Yes standard psu width is usually 150mm x 86mm high
It's the length that can vary
Small form factor psus would be smaller dimensions
Obviously than 150mm x 86mm

But understand what you mean
Start the build and you want to finish it in one go
It's the same with custom watercooling
I dont want to wait for 1 fitting or more tubing to
Be delivered if I miscalculated
So usually pop down the local car factors or plumbers
And grab stuff from there
Car tubing actually stronger and much more heat resistant
Than actually pc watercooling tubing anyway
 
Yeah man that actually happened to me on my last build. Had all my stuff ready to build but GPU was on back order for a few months. Finally got the GPU and popped a water block on it and only then realized that the 90° fittings I'd bought months ago were not the rotary ones I needed! It was either rethink the hard tubing layout or else go order new fittings and wait 2 weeks for delivery. I chose the latter, never even thought of checking out the local plumbers!

I have a big horde of extra fittings of all types tucked away though, so this time around if I run into any hassle I won't be caught short (hopefully LOL)
 
You must log in or register to reply here.
Back
Top Bottom