After loads of help from this excellent forum, I finally speccd, ordered and yesterday, built my new system.
I have a small issue, in that my old Coolermaster case is just a tiny bit too narrow to fit in the new cpu cooler.
There was already a hole in the side panel, but typically this isn't quite in the right place
I think I have 3 options:
1 - buy a new case - not an option - no dollar left
2 - make the hole in the side bigger, using probably a jigsaw and a file
3 - leave the side off
The pooter usually lives underneath my desk in a kind of tunnel - can take a pic if needed.
What say you? Answers gratefully received
I have a small issue, in that my old Coolermaster case is just a tiny bit too narrow to fit in the new cpu cooler.
There was already a hole in the side panel, but typically this isn't quite in the right place
I think I have 3 options:
1 - buy a new case - not an option - no dollar left
2 - make the hole in the side bigger, using probably a jigsaw and a file
3 - leave the side off
The pooter usually lives underneath my desk in a kind of tunnel - can take a pic if needed.
What say you? Answers gratefully received
